Applied Surface Science Advances (Feb 2023)
Rapid fabrication of CuMoO4 nanocomposites via electric field assisted pulsed-laser ablation in liquids for electrochemical hydrogen generation
Abstract
Transition–metal-doped electrocatalysts are considered as low-cost alternatives of Pt and RuO2 electrocatalysts for large scale electrochemical generations of hydrogen and oxygen, respectively. Although, chemical synthesis, typically adopted to produce these electrocatalysts, is scalable but hazardous by-products and chemical wastes create growing environmental concerns. Here, we developed a single step, single pot, and environmentally friendly physical approach of electric field-assisted pulsed laser ablation in liquid for the synthesis of colloidal solution of pure CuMoO4 (CMO) electrocatalysts. The entire process took few minutes and did not involve or generate any chemical. A pulsed picosecond laser was used to ablate MoS2 target at the solid-liquid interface to generate spatially confined plasma plume. Two parallel electrodes (copper sheets) were mounted around the plasma plume to modulate the plasma parameters, control the reactions at the plasma-liquid interface, and simultaneously inject copper ions from the electrode to the laser-produced plasma (LPP) for the generation of CMO. nanoparticles. Surprisingly, we observed that by varying the applied electric field, we can efficiently control the size, shape, crystallinity, morphology, and composition of as produced CMO nanocomposites and enhance their hydrogen evolution reaction (HER) performance. The characterization results proves that the introduction of applied electric field during the laser ablation process significantly change the morphology of as-prepared nanomaterials, and the shape of these nanomaterials were spherical, spindle and cuboid for MoS2, CuO and CMO respectively. Among all the fabricated electrocatalysts, CMO-60 is the best HER performer in alkaline medium, while MoS2 and CuO nanoparticles were the worse. For CMO-60 sample, only 440 mV overpotential required to reach the current density of 10 mA/cm2 and as well as posess good stability. We found that electrocatalysts produced at a higher electric field have higher contents of copper and oxygen leading to a superior HER activity. The developed approach can be applied for the synthesis of other electrocatalysts for a range of chemical reactions.
