Experimental study on electrode wear during the EDM of microgrooves with laminated electrodes consisting of various material foils

Abstract

Electrode wear during electrical discharge machining (EDM) is inevitable, and tool electrodes of different materials exhibit different wear rates. Unlike a single-material tool electrode, for a laminated electrode consisting of various material foils (LE-VMF), the components suffer from significantly different amounts of wear and also influence each other in EDM, however, the form and cause of the wear are not clear. Thus, the LE-VMFs including symmetric and asymmetric LE-VMFs were prepared and used in EDM in this paper. The wear of foils in LE-VMFs and their mutual influence during the EDM process were investigated through experiments. The wear forms of a single foil electrode and a foil of the same material in the LE-VMF were also compared. The experimental results show that copper foil with a lower wear rate had a protective effect on an adjacent brass foil with a larger wear rate in the LE-VMF, while the protective effect of the brass foil in the symmetric LE-VMF was larger than that in the asymmetric LE-VMF. The closer the distance from the copper foil, the stronger was the protection effect and the smaller was the wear. In addition, the working surface of the brass foil in the LE-VMF did not show any concavity-like wear in the middle region of its thickness after EDM, as was the case for the single brass foil electrode, even if the thickness of the brass foil was greater than 150 μm.

Keywords

• Electrical discharge machining
• Laminated electrode
• Electrode wear
• Protective effect