Archives of Electrical Engineering (Mar 2022)
Maximization of injected power and efficiency based optimal location of DPFC using iterative procedure
Abstract
Among the FACTS device, the distributed power flow controller (DPFC) is a superior device. This can be evaluated after eliminating the dc capacitor between shunt and series convertors of the unified power flow controller (UPFC) and placing a number of low rating single phase type distributed series convertors in the line instant of using single large rating three phase series convertors as in the UPFC. The power flow through this dc capacitor as in the UPFC now takes place through the transmission line at a third harmonic frequency in the DPFC. The DPFC uses the D-FACTS that allows the replacement of a large three-phase converter as in the UPFC by several small-size series convertors present in the DPFC. The redundancy of several series convertors increases the system’s reliability of the power system. Also, there is no requirement for high voltage isolation as series convertors of the DPFC are hanging as well as single-phase types. Consequently, the DPFC system has a lower cost than the UPFC system. In this paper, the equivalent ABCD parameters of the latest FACTSdeviceDPFChave been formulated with the help of an equivalent circuit model of the DPFC at the fundamental frequency component. Further, the optimal location in the transmission line and maximum efficiency of the DPFC along with Thyristor Controlled Series Compensator (TCSC), Static Synchronous Shunt Compensator (STATCOM) and UPFC FACTS devices have been investigated using an iteration program developed in MATLAB under steady-state conditions. The results obtained depict that the DPFC when placed slightly off-center at 0.33 fraction distance from the sending end comes up with higher performance. Whereas, when the TCSC, STATCOM and UPFC are placed at 0.16, 0.2815, 0.32 fraction distances from sending end respectively give their best performance.
Keywords
