Use of Spinning Rollers for Surface Densification of Wood

Abstract

In this study, softwood cedar of Lebanon (Cedrus libani A.Rich.) and hardwood black poplar (Populus nigra L.), turned into cylinders by turning, were subjected to a surface densification process. Densification was carried out on the lathe using the spinning roller designed and manufactured for this purpose. Hardness, brightness and roughness (Rz) measurements were carried out on undensified and densified regions of the cylindrical solid wood materials. An increase in hardness and brightness and a decrease in roughness values occurred under all densification conditions. The highest surface hardness values occurred in cedar of Lebanon at 0.081 mm/rev feed, 200 rpm spindle speed, and 1 mm densification depth. On densified wood surfaces, as the feed from the densification parameters increases, the hardness decreases, and as the densification depth increases, the hardness increases-. The effect of surface densification parameters on the gloss and roughness results of the samples shows no linear effect in terms of experimental parameters. In both species, lower spring back was obtained at low depth of densification.

Keywords

• surface densification
• spinning roller
• roughness
• glossiness
• hardness