FEM Simulation on First-Step Drawing Process of Platinum-Clad Nickel Bars

Abstract

The purpose of this study is to investigate the effects of semi-angle and platinum tube wall thicknesses on the first-step drawing process of platinum-clad nickel bars using finite element simulation. Three different semi-angles of die (3°, 5°, 7°) and three different platinum tube wall thicknesses (0.275 mm, 0.3 mm, 0.325 mm) were selected in the study. The effects of semi-angle and platinum tube wall thicknesses on drawing force, equivalent stress, cladding behavior and damage coefficients during the first-step drawing process were discussed in detail. The simulated results of cladding condition and damage obtained from Deform 3D V11 software are validated with experimental results, and it was found that the results were in good agreement. The results of this study may provide a reference for the practical production of platinum-clad nickel wires.

Keywords

• platinum-clad nickel
• first-step drawing
• semi-angle of die
• platinum tube wall thickness
• FEM simulation