Electrocatalytic properties and stability of titanium anodes activated by the inorganic sol-gel procedure

Abstract

The properties of activated titanium anodes, RuO2-TiO2/Ti and RuO2--TiO2-IrO2/Ti, prepared from oxide sols by the sol-gel procedure, are reviewed. RuO2 and TiO2 sols were synthesized by forced hydrolysis of the corresponding chlorides in acid medium. The morphology of the prepared sols was investigated by transmission electron microscopy. The chemical composition of the RuO2 sol was determined by X-ray diffraction and thermogravimetric analysis. The loss of electrocatalytic activity of a RuO2-TiO2/Ti anode during an accelerated stability test was investigated by examination of the changes in the electrochemical characteristics in the potential region of the chlorine and oxygen evolution reaction, as well as on the open circuit potential. These electrochemical characteristics were investigated by cyclic voltammetry, electrochemical impedance spectroscopy and polarization measurements. The changes in electrochemical characteristics of the anode prepared by the sol-gel procedure were compared to the changes registered for an anode prepared by the traditional thermal decomposition of metal chlorides. The comparison indicated that the main cause for the activity loss of the sol-gel prepared anode was the electrochemical dissolution of RuO2, while in the case of thermally prepared anode the loss was mainly caused by the formation of an insulating TiO2 layer in the coating/Ti substrate interphase. The results of an accelerated stability test on RuO2-TiO2/Ti and RuO2--TiO2-IrO2/Ti anodes showed that the ternary coating is considerably more stable than the binary one, which is the consequence of the greater stability of IrO2 in comparison to RuO2.

Keywords

• activated titanium anodes
• oxide sols
• coating morphology
• electrocatalytic properties
• anode stability