Multidimensional Data Interpretation of Vibration Signals Registered in Different Locations for System Condition Monitoring of a Three-Stage Gear Transmission Operating under Difficult Conditions

Abstract

This article provides a discussion of the results of studies on the original system condition monitoring of a three-stage transmission with a bevel–cylindrical–planetary configuration installed in an experimental scraper conveyor. Due to the high vibroactivity of gear transmissions operating under the impact of a scraper conveyor’s chain drive, these unwanted effects of machine operating vibrations were assumed to be applied. For purposes of the study, vibrations were measured on the driving transmission housing in an idling scraper conveyor. The main purpose of the study was to establish the frequencies characteristic of the gear transmission, and to determine whether it was possible to run vibroacoustic diagnostics of the same transmission under conditions with a considerable impact of the conveyor chain. An additional cognitively significant research goal was the analysis of the dependence of the diagnostic utility of the signal depending on the sensor mounting point. Five different locations of three-axis sensors oriented to the next stages and various types of gears were determined, as well as places characterized by high spatial accessibility, which are often selected as places for measuring the vibration of gears. Using MATLAB software, a program was written that was calibrated and adapted to the specifics of the measuring equipment based on the collected test results. As a result, it was possible to obtain a multidimensional data interpretation of vibration signals of system condition monitoring of a three-stage gear transmission operating under difficult conditions. The results were based on signals registered on the real three-stage gear transmission operating under the impact of a scraper conveyor’s chain drive.

Keywords

• vibrations
• gear transmission
• sensor location
• STFT
• FFT
• waveform