Heat transfer and fluid flow in nano-encapsulated PCM-filled undulated cavity

Abstract

This article discusses the heat transfer characteristics of the mixed convection of NEPCM-fluid (Polyurethane/ Nonadecane dispersed in water) contained within a wavy-sided walls cavity. Mixed convection is caused by an adiabatic rotating cylinder located in the cavity center, while natural convection results from deferential heating of side walls. The upper and lower walls of the cavity are insulated. The Galerkin finite element method (GFEM) implemented in COMSOL CFD package is employed to solve the governing equations. The influence of the nanoparticles volume fraction (Ø = 0.02, and 0.05), cylinder radius (R = 0.05, 0.15, and 0.25), cylinder rotating speed (Ω = 100, −500, 500, and 1000), the dimensionless fusion temperature (θfu = 0.1, 0.25, and 0.5), wavy side walls undulation peaks number (N = 1 to 4) on the flow pattern and temperature field are presented. The results revealed that the heat transfer enhances by increasing the angular speed of the cylinder and its radius, also an enhancement in heat transfer is obtained by upgrading the volume fraction of NEPCM, however, it was noticed that for small cylinders, the counterclockwise rotation of the cylinder reduced the heat transfer rate as the rotation opposed the direction of natural heat convection. In addition, the waviness pattern has a specific impact on each case, for example, N = 4 denotes the best result for only the cases Ω = -500 or 500 when R = 0.25 and Ø = 0.05, while the heat transfer is negatively affected by increasing N for the other cases. On another hand, the impact of θfu on the heat transfer rate was found to be insignificant. Globally, at the biggest cylinder radius, higher Ø and highest angular speed an enhancement by more than 900 % can be achieved.

Keywords

• NEPCM
• Numerical Study
• Heat transfer
• Mixed convection
• Rotating cylinder
• Wavy wall