Sustainable Alternative Materials to Concrete Masonry Partition Walls: Light-Weight Wall Panel Using Polymethyl Methacrylate (PMMA) and Shredded Waste Metalized Film Packaging

Abstract

The amount of plastic waste produced yearly is significantly increasing. Approximately 300-400 million metric tons of plastic waste are produced yearly. One of the dominant plastic wastes is a metalized film, a shiny, non-homogeneous polymer used in packaging that is considered the least recycled. Meanwhile, partition walls in buildings are traditionally made of concrete masonry, one of the most utilized materials in the construction industry globally, consumed yearly by about 11 billion metric tons. Because of the excessive use of concrete, the necessary raw materials are undeniably depleting, therefore demanding some alternatives. Polymethyl methacrylate (PMMA) is one option that can be utilized as an alternative because of its remarkable characteristics better than that of the traditional. This paper proposed the utilization of PMMA in fabricating the hollow panel filled with shredded waste metalized film packaging resulting in the lightweight wall panel being used as an alternative to concrete masonry for constructing partition walls. After the experiment, PMMA produced compressive strength of 75.30-84.30MPa, a tensile strength of 52.00-59.10MPa, a flexural strength of 102.00-107.00MPa, and water absorption of 0.80-0.90%. Also, shredded waste metalized films add aesthetic to the panel and are complemented by the remarkable transparency of PMMA. In conclusion, using this lightweight wall panel instead of traditional concrete masonry partition walls will reduce plastic waste in landfills and the raw materials necessary to produce concrete.

Keywords

• plastic wastes, metallized film packaging, partition walls, polymethyl methacrylate