Defectoscopic and Geometric Features of Defects That Occur in Sheet Metal and Their Description Based on Statistical Analysis
Ihor Konovalenko,
Pavlo Maruschak,
Halyna Kozbur,
Janette Brezinová,
Jakub Brezina,
Anna Guzanová
Affiliations
Ihor Konovalenko
Department of Industrial Automation, Ternopil National Ivan Puluj Technical University, Rus’ka Str. 56, 46001 Ternopil, Ukraine
Pavlo Maruschak
Department of Industrial Automation, Ternopil National Ivan Puluj Technical University, Rus’ka Str. 56, 46001 Ternopil, Ukraine
Halyna Kozbur
Department of Industrial Automation, Ternopil National Ivan Puluj Technical University, Rus’ka Str. 56, 46001 Ternopil, Ukraine
Janette Brezinová
Department of Technology, Materials and Computer Supported Production, Faculty of Mechanical Engineering, Technical University of Košice, Mäsiarska 74, 040 01 Košice, Slovakia
Jakub Brezina
Department of Technology, Materials and Computer Supported Production, Faculty of Mechanical Engineering, Technical University of Košice, Mäsiarska 74, 040 01 Košice, Slovakia
Anna Guzanová
Department of Technology, Materials and Computer Supported Production, Faculty of Mechanical Engineering, Technical University of Košice, Mäsiarska 74, 040 01 Košice, Slovakia
Features of the defect class “scratches, attritions, lines”, their geometric structure, and their causes are analyzed. An approach is developed that defines subclasses within this class of technological defects based on additional analysis of morphological features. The analysis of the reasons for these subclasses allows additional information to be obtained about the rolling process, identifying additional signs of defects, regulating the rolling conditions of steel strips more accurately, and diagnosing the equipment condition.