Metals (Apr 2024)

Strip Casting of Sm<sub>2</sub>TM<sub>17</sub>-Type Alloys for Production of the Metastable SmTM<sub>7</sub> Phase

  • Richard Sheridan,
  • Joseph Gresle-Farthing,
  • Alice Appleby,
  • Mangaliso Brown

DOI
https://doi.org/10.3390/met14050517
Journal volume & issue
Vol. 14, no. 5
p. 517

Abstract

Read online

Conventional book casting of Sm2TM17-type alloys (where TM = Co, Fe, Cu, Zr) leads to a coarse, highly segregated microstructure, predominantly due to the slow, variable cooling rate from the mould surface towards the centre of the ingot. These cast alloys require a long homogenisation treatment to remove this segregation and develop a super-saturated, metastable SmTM7-type hexagonal phase. This SmTM7 phase is a vital precursor phase required during magnet production to develop the complex cellular structure responsible for high magnetic properties. In this work, strip casting was employed to facilitate rapid solidification to develop thin flakes (7 phase. This could remove or significantly reduce the need for the energy-intensive homogenisation treatment usually required in conventional magnet manufacture. This paper investigates the effect of wheel speed (and hence cooling rate) on flake thickness, microstructure, and phase balance of the cast alloys. It was shown that for wheel speeds between 1.1 and 3.0 m/s, the microstructure showed large variation; however, in all cases, evidence of the columnar SmTM7 phase was presented. The adhesion between the melt and the wheel was deemed to be critical for the nucleation and subsequent columnar growth of SmTM7 grains, where the wheel speed controlled both the flow of the alloy onto the wheel and the thickness of the resultant flake. It was determined that in order to achieve a homogenous columnar SmTM7 structure, the maximum flake thickness should be limited to 270 μm to avoid the formation of equiaxed Sm2TM17 grains through insufficient cooling.

Keywords