Microstructure and Indentation Properties of Single-Roll and Twin-Roll Casting of a Quasicrystal-Forming Al-Mn-Cu-Be Alloy

Abstract

In this investigation, strips of an experimental Al-Mn-Cu-Be alloy were manufactured by high-speed single-roll and twin-roll casting to stimulate the formation of a quasicrystalline phase during solidification. The strips were characterised by light microscopy, scanning and transmission electron microscopy, microchemical analysis, and X-ray diffraction. Indentation testing was used to determine the mechanical responses of the strips in different areas. A smooth surface was achieved on both sides of the twin-roll-cast strip, while the free surface of the single-roll-cast strip was rough. The microstructures in both strips consisted of an Al-rich solid solution matrix embedding several intermetallic phases Θ-Al2Cu, Be4Al (Mn, Cu), Al15Mn3Be2 and icosahedral quasicrystalline phase (IQC). The microstructure of the single-roll-cast strip was more uniform than that of the twin-roll-cast strip. Coarse Al15Mn3Be2 particles appeared in both alloys, especially at the centre of the twin-roll strip. These coarse particles adversely affected the strength and ductility. Nevertheless, both casting methods provided high-cooling rates, enabling the formation of metastable phases, such as quasicrystals. However, improvements in alloy composition and casting procedure are required to obtain enhanced microstructures and properties.

Keywords

• single-roll casting
• twin roll casting
• microstructure
• quasicrystal
• hardness
• aluminium