Development and Testing of an Individualized Sensorised 3D Printed Upper Limb Bicycle Prosthesis for Adult Patients

Abstract

This paper presents the outcomes of investigations conducted on the development procedure of a personalized prosthetic device for an adult patient. The individualization is achieved through 3D scanning, followed by semi-automated design using the AutoMedPrint system, and low-cost fused deposition modelling (FDM) technology for 3D printing. The prosthesis is aimed for use during bicycle riding and other sport activities. During the conducted experiments outlined in this manuscript, the prosthesis is equipped with force and movement sensors. The purpose is to collect data on its functionality across different scenarios and dynamic activities, aiming to assess potential harm, refine the design, and serve as an initial step before activating the prosthesis end effector. This article describes the methodology in detail, including the process of designing, producing, and programming, as well as laboratory and field test results (including testing performed with and without a patient). Overall, the design and prototype are implemented successfully. A discussion about the need for particular improvements in both the mechanical and electrical areas is finally presented.

Keywords

• upper limb prosthesis
• 3D printing
• wearable sensors