Nitrogen Utilization from Ammonium Nitrate and Urea Fertilizer by Irrigated Sugarcane in Brazilian Cerrado Oxisol

Abstract

Sugarcane is the most promising among renewable biofuel-producing crops. An adequate availability of water and nutrients, especially nitrogen (N), is of utmost importance. From the hypothesis that the source and the rate of N fertilization influence the N use efficiency of an irrigated soil–sugarcane system, this study aimed to evaluate the stalk and crop residues (pointer and leaves) yield, as well as the N utilization, from different rates of ammonium nitrate and urea by irrigated sugarcane in the cane plant cycle, using an 15N isotopic dilution technique. The soil used for the experiment was an Oxisol (Rhodic Haplustox) Cerrado (savannah) phase. The experiment was carried out at a farm of the Raízen Mill, which was located in the municipality of Jataí, Goias State, Brazil. The sugarcane variety IACSP95–5000 was used in a randomized block design, with three replicates, four N rates (30, 60, 120, and 180 kg ha−1), and two fertilizer sources labeled with 15N isotopes (urea and ammonium nitrate). The average value for N utilization was 60.17% for the ammonium nitrate source and 44.95% for urea. The responses in the percentage and quantity of N in the sugarcane from the fertilizer increase with the increasing N rate. The soil was the main N source for sugarcane. The higher stalk and pointer yield was recorded at the average rate of 143.61 kg N ha−1. Further studies are needed to evaluate the residual effect of N in the next cycles.

Keywords

• <i>Saccharum</i> spp.
• stalk yield
• N recovery
• nitrogen-15
• Oxisol
• cerrado