Prediction of tensile strength of injection-molded GF/PA considering effects of reinforcement fiber diameter and interfacial properties

Abstract

Fiber reinforced thermoplastics (FRTP) attracts attention as a lightweight material for mass-produced automobiles due to advantages such as excellent formability and recyclability in addition to high specific strength and specific rigidity. Many factors influence the improvement of the mechanical properties of FRTP. We have revealed that the tensile strength of injection-molded glass fiber/polyamide66 (GF/PA) improves as the reinforcement fiber diameter decreases in the wide strain rate range in previous researches. In addition, it was suggested that by using a strength prediction model of discontinuous fiber reinforcement, if the strength can be obtained for one diameter, the strength can be predicted for other diameters. In this study, we investigated the mechanism of the strength enhancement of the GF/PA associated with thinning of the reinforcement fibers and increase of the strain rate. To ascertain the interface properties, single-fiber pull-out tests were conducted on the GF/PA and it was confirmed that the interfacial shear strength (IFSS) of the GF/PA had strain rate dependency. The strength prediction of the GF/PA with the strain rate dependency of IFSS taken into account showed values closer to the experimental values than the values obtained from the prediction with an assumption that IFSS is constant regardless of the strain rate. Furthermore, investigating the factor of the increase in strength due to the thinning of the fibers suggested that the increase of the fiber strength is the dominant factor.

Keywords

• composite materials
• strain rate dependency
• impact properties
• interfacial properties
• lft
• fiber diameter