In Vitro Investigation of the Mechanical Properties of Blended 3D-Printing Resins for Orthodontic Aligners: A Comparison between Commercial Resin and Nickel-Titanium Wire

Abstract

This scientific article investigates the mechanical properties of a novel three-dimensional-printing resin specifically designed for orthodontic aligners and compares it to other commonly used resins. The resin was made by blending two commercially available and certified resins to produce aligners with improved mechanical properties compared to each separate resin. The study examined the effect of the addition of NextDent Ortho Rigid resin on the mechanical properties of the specimens, more specifically analyzing the relationship between the amount of the added rigid resin and the mechanical properties of the specimens. The mechanical properties of the specimens and the nickel-titanium wires were analyzed using a three-point bending test setup. The results showed no statistically significant differences within the different groups of specimens. The study provides valuable insights into the potential of the resin to meet the mechanical demands of orthodontic treatments. It will contribute to the advancement of personalized orthodontic care through three-dimensional-printing technology. Blending commercially available and certified resins enables orthodontic practitioners to select the most suitable resin for each case, providing better outcomes for patients and increasing the efficiency of the treatment process. Further research and evaluation would be required to determine the suitability of the blended resin for orthodontic treatments.

Keywords

• 3D-printing resin
• mechanical properties
• orthodontic aligners
• three-point bending test