Modeling of Selected Parameters of Used Lubricating Oil Diluted with Diesel Oil Using the Characteristics of Fresh Lubricating Oil

Abstract

This article presents the verification of the hypothesis on using certain approximation curves in the evaluation of used lubricating oil. These curves are plotted for fresh lubricating oil to approximate the parameters of lubricating oil diluted with diesel oil. To confirm the hypothesis, an experiment is conducted to determine the flash point, initial boiling point, density at 15 °C, kinematic viscosity at 40 °C and 100 °C, and viscosity index. The analysis covers fresh oil and used SAE 30 grade Marinol CB-30 RG1230 oil taken from the circulating lubrication system of a supercharged, trunk-piston, 4-stroke ZUT Zgoda Sulzer 5 BAH 22 engine that is located in the Marine Power Plant Laboratory of the Maritime University of Szczecin. Undiluted lubricating oils (both fresh and used) and mixtures of lubricating oils with diesel oil are examined for diesel oil concentrations in the mixture equal to 1, 2, 5, 10, 15, and 20% m/m. Orlen Efecta Diesel Biodiesel is used to prepare the mixtures. The functions approximating the parameters for fresh oil are determined and adapted to describe the variation of the same parameters for the used lubricating oil. For each case, the coefficient of determination, the maximum relative error of the model fitting to the experimental results, and the root mean square error (RMSE) are determined. In the experiment, the variation in the parameters of the used lubricating oil remained the same as for fresh oil parameters. Thus, the research hypothesis is confirmed.

Keywords

• fuel dilution
• lubricating oil
• diesel oil
• flash point
• initial boiling point
• density