In Vitro Corrosion Performance of As-Extruded Mg–Gd–Dy–Zr Alloys for Potential Orthopedic Applications

Abstract

In this study, different contents of rare earth elements with high solid solubility (Gd and Dy) were added into Mg and fabricated through homogenization and hot extrusion processes that enable few second phase formation to efficaciously inhibit the galvanic corrosion. The microstructure and phase characterization of the as-extruded Mg–Gd–Dy–Zr alloys were analyzed by scanning electron microscopy, electron backscattered diffraction, and X-ray diffraction. The in vitro biodegradation behavior of the as-extruded Mg–Gd–Dy–Zr alloys was investigated via the electrochemical measurement and immersion test. The results revealed that all the as-extruded alloys with different RE additions exerted fully recrystallized microstructures. The average grain size was appropriately 20 μm to 30 μm for all alloys and gradually increased by adding more RE. Only a few tiny second-phase particles less than 5 μm dispersed for all the samples and the volume fraction of particles increased slightly with the increase in RE content. The as-extruded Mg–Gd–Dy–Zr alloys with low RE content (GD0.6) allowed for a satisfactory corrosion resistance in Hank’s solution with a controlled corrosion rate less than 0.5 mm/year, which is considered as the tolerance limit for the corrosion rate of orthopedic implants. This study provides a cost-effective choice for promoting biodegradable magnesium alloys for potential orthopedic applications with low rare earth content in Mg alloys.

Keywords

• Mg–Gd–Dy–Zr alloys
• corrosion performance
• orthopedic