Comparison of elastic properties of periodic and aperiodic porous structures produced by additive methods

Abstract

The aim of this work was to design, print, and examine elastic properties of porous structures with various parameters and beam distributions. These structures, generated using an algorithm, featured three types of lattices: octet, cubic, and Voronoi diagram-based, with different porosities (40 %, 60 %, 80 %) and beam sizes (0.45 mm, 0.66 mm). They were printed using Direct Light Processing and examined using X-ray computed microtomography. Compression tests were conducted to determine the Young’s modulus. The results were compared with computer simulations performed using Abaqus. The tools used, such as 3D printing and X-ray computed microtomography, were described, and the results and conclusions of the tests were presented. As a result, comparable outcomes were obtained for structures with higher beam diameter, while significantly different results were observed for structures with lower beam diameter.

Keywords

• porous structures
• elastic properties
• FEM simulations
• 3D printing
• microtomography