Efficacy of FRP Hooping in Masonry Domes: A Simple Numerical Approach

Abstract

A simple numerical approach to predict the efficacy of FRP hooping in historical masonry domes is presented. The dome is modelled with 8-noded elastic hexahedron elements connected by 1D trusses/springs on meridians and on parallels, where all the non-linearity takes place. The aim is to simulate the nonlinear behaviour of domes through every FE commercial software equipped only with non-linear 1D elements, namely point contacts and cutoff bars. The constitutive behaviour of the trusses is assumed to be either perfectly brittle or perfectly ductile. A possible orthotropic behaviour and the no-tension material case can be reproduced. External retrofitting is simulated using trusses with an elastic perfectly ductile behaviour, assuming a perfect bond between the substrate and the reinforcement and imposing an ultimate strength for the trusses, which takes into account the possible debonding/delamination from the substrate in a conventional way. The Italian code CNR DT200 and the existing specialized literature are used as references. The models are benchmarked on a masonry dome reinforced with three hooping FRP strips and experimentally tested at the University Architecture Institute of Venice IUAV, Italy. The procedure is validated through extensive comparisons with available experimental data and numerical results obtained in the literature with a variety of different models. Through the extensive comparisons that were made and discussed, the robustness and simplicity of the procedure are proven.

Keywords

• FRP
• hoop reinforcement
• masonry domes
• non-linearity
• collapse load
• FEM