Effects of tensile stress on electrochemical characteristics and structural morphology of P110SS steels in carbon dioxide-saturated solution

Abstract

A high-temperature autoclave was used to grow CO _2 corrosion-product films on P110SS steel specimens while the surface of the specimens was continuously subjected to tensile stress in a four-point bending jig; the autoclaving times were 6, 18, 36, and 72 h. A scanning electron microscope was used to observe the surface topography of the corrosion-product films formed on the P110SS steels. An x-ray diffraction was used to analyze the phase compositions of the corrosion products. The electrochemical performance of the films was investigated using electrochemical impedance spectroscopy and potentiodynamic polarization curves. The results showed that tensile stress could hinder the formation of corrosion-product films; the integrity and compactness of the films worsened, but the phase compositions of the films did not change. The applied tensile stress resulted in a smaller grain size of the corrosion-product films, and the grain boundaries increased. In addition, owing to the induced tensile stress, the charge transfer resistances decreased, and the corrosion current densities increased for the P110SS steels with corrosion-product films in a 3.5 wt% NaCl solution saturated with CO _2 .

Keywords

• tensile stress
• corrosion-product films
• CO2 corrosion
• electrochemistry
• SEM