Impact of Sawmill Processing on the Yield and Longitudinal Warping of Beech Blanks

Abstract

This study focused on the impact of the wood sawing pattern on 50 mm thick beech timber, followed by cross-cutting on the 3 m long, 50 × 50 mm beech blanks. The study analyzed two methods of cutting patterns of beech blanks (parallel to the surface of the timber and parallel to the grain fiber of the timber) regarding yield values and the size of longitudinal warping after air-drying. The yield values were higher (from 65.14 to 72.70 %) when producing long beech blanks using the method of sawing parallel to the timber’s axis (B) compared to parallel to the edge of the blank (from 60.38 to 68.40 %). Results showed that a crucial factor for choosing the cutting method (A or B) is the taper of the logs. For blanks with a taper ≥ 1.3 cm.m-1, it is more advantageous in terms of longitudinal warping and yield to use the method of sawing parallel to the timber's axis.

Keywords

• longitudinal warping of wood
• blanks
• beech
• yield
• sawmill process