Screen-printed electrodes on paper using copper nano- and micro-particles

Abstract

Screen-printed copper electrodes have the potential to replace silver and lithium electrodes in printed batteries and sensors owing to the abundance of copper, its competitive electrical properties, and the low cost of raw materials. Herein, copper microparticle-glycerol-based inks were screen-printed onto paper to develop highly conductive electrodes. The conductivity and particle connectivity enhancement of screen-printed electrodes are the main research topics. These parameters translate to usability including increased sensitivity for sensor applications and reduced resistivity for battery electrode applications. CuO nanoparticles of 50 nm were deposited onto the electrodes at a concentration of 1 μl/cm2, which led to a 4-fold decrease in sheet resistivity from 200 to 50 Ω/m2. The increased connectivity and formation of new channels due to the addition of nanoparticles were visualised via field emission scanning electron microscopy. The CuO nanoparticles were developed via a hybrid approach incorporating wet chemistry for high yield and laser ablation for colloidal conductivity and Zeta potential enhancement which reached up to −45 mV. An optimal screen-printing viscosity of 62 mPa s was achieved through a precise 1.95:1 mass ratio of Cu microparticles to glycerol. Heat treatment at 100 °C after screen-printing enhanced particle connectivity by reducing glycerol content in the ink.

Keywords

• Screen-printing
• Battery electrodes
• Copper electrodes
• Printed batteries
• Nanoparticles
• Additive manufacturing