The relationship between the ‘‘Fujisawa point’’ and anatomical femorotibial angle following simulated open wedge high tibial osteotomy

Abstract

Abstract Background We evaluated the relationship between the weight-bearing line (WBL) ratio and anatomical femorotibial angle (FTA) by simulated open wedge high tibial osteotomy (OWHTO). This study evaluated the correlation between the ‘‘Fujisawa point’’ and FTA, and identified factors which caused deviations between the two measurement methods. We hypothesized that the Fujisawa point corresponded with 170° of the FTA. Methods Preoperative antero-posterior full-length lower limb radiographs of 82 patients were obtained for the OWHTO to place the WBL ratio at a target of 62.5% of the width of the tibial plateau (Fujisawa point). The coronal alignment was measured pre- and post-planning. The patients were divided into two groups by the post-planning FTA: a correspondence group (168.5°≦FTA≦171.5°) and a non-correspondence group (FTA < 168.5°, 171.5° < FTA). The relationship between the Fujisawa point and the FTA was analyzed with multivariate regression analysis. Results The post-planning FTA was 169.8 ± 1.1° and within 170 ± 1.5° in 69 cases (84.1%) when the WBL ratio was 62.5%. The neck shaft angle was 128.1 ± 5.2° in the correspondence group, and 122.3 ± 6.3° in the non-correspondence group. The multivariate linear regression analysis revealed that the neck shaft angle was the only factor that predicted the correspondence of the Fujisawa point with the FTA at 170° (p = 0.006, odd 1.28). Conclusions The post-planning FTA converged at 170° when the WBL ratio passed through the Fujisawa point and the neck shaft angle was the only predictor.

Keywords

• Open wedge high tibial osteotomy (OWHTO)
• Fujisawa point
• Femorotibial angle (FTA)
• Hip-knee-ankle angle (HKA)
• Neck shaft angle