Research and Application of Fast Plugging Method for Fault Zone Formation in Tarim Basin, China

Abstract

The Silurian strata in the Shunbei No. 5 fault zone have the characteristics of long open holes, easy leakage and complex leakage. In the early stages, plugging technologies and methods such as bridging plugging, cement, chemical consolidation and high-water-loss plugging have poor effects and low plugging efficiency. Plugging slurry directly prepared with drilling fluid has low filtration characteristics, and the main reason is that the plugging material cannot filter quickly after the fluid enters the fracture. Based on the basic principle of fast filtration, the main plugging fluid M-Fluid, the micro-elastic high-strength main plugging agent M-Block and the filling agent Filling-Seal have been developed. In combination with the water-loss and wall-building properties of the circulating drilling fluid after plugging, a fast plugging technology for fractured volcanic rock formation has been established. The laboratory evaluation experiment showed that the filtration rate increased rapidly with the increase of temperature, and the filtration rate was about 0.31~0.79 mL/s, while the filtration rate of the drilling fluid was 0.0067 mL/s under the same conditions. The pressure-bearing capacity of various plugging evaluation methods, such as the simulated fracture of a large-grain sand bed, artificial fracture of small core and full-size core and multi-form fracture of double core, all exceed 5 MPa, and the system has a good plugging effect for complex fractures.

Keywords

• lost circulation
• fault zone
• Silurian
• quick plugging
• pressure-bearing capacity
• plugging technology