PLoS ONE (Jan 2024)

Pore structure characterization and its influence on aqueous phase trapping damage in tight gas sandstone reservoirs.

  • Qing Guo,
  • Xiaojia Lu,
  • Tao Liu,
  • Mengtao Yang,
  • Kai Wang,
  • Yande Zhao,
  • Liang Tao

DOI
https://doi.org/10.1371/journal.pone.0298672
Journal volume & issue
Vol. 19, no. 4
p. e0298672

Abstract

Read online

Aqueous phase trapping (APT), which is one of the most prominent damages, seriously restricts the natural gas production in tight gas sandstone with low permeability. Pore size and microscopic pore structures are the most important factors to determine the water blocking damage. In this paper, 9 core samples from tight gas sandstone with various physical properties were employed, and the pore size distribution (PSD) of the core samples were investigated by high pressure mercury intrusion tests (HPMI). Results showed that the porosity of core samples ranges from 5.68% to 13.7%, and the permeability ranges from 0.00456 to 7.86 mD, which is a typical tight reservoir with strong heterogeneity. According to the HPMI capillary curve, the cores can be divided into two types: Type I and Type II, and the pore sizes of type I are larger than that of type II. Fractal distributions were obtained using HPMI data to further determine the pore structure characteristics of tight reservoirs. The pore structures of tight sandstones display the multifractal fractal feature: D1 corresponding to macro-pores, and D2 corresponding to fractal dimension of micro-pores. Furthermore, APT damage was determined by the permeability recovery ratios (Kr) after gas flooding tests. The correlation of Kr and PSD and fractal dimensions were jointly analyzed in tight gas sandstone. Although positive correlations between pore size parameters and the permeability recovery ratios were observed with relatively weak correlations, for those core samples with very close permeability, pore size parameters (both permeability and PSD) is inadequate in clarifying this damage. The fractal dimension can well describe the complexity and heterogeneity of flow channels in pores, which can become the determining factor to distinguish the flow capacity of tight sandstone. The D2 for samples of type I and type II exhibited a good negative relation with Kr with a correlation coefficient of 0.9878 and 0.7723, respectively. The significance of this finding is that for tight gas sandstone, fractal dimensions, especially the small pore fractal dimension (D2), can be used to predict the possible APT damage very well.