Materials Research Express (Jan 2024)
Impacts of T6 heat treatment on the microstructural, mechanical, and corrosion properties of thixoformed AA7075 alloy produced by cooling slope casting
Abstract
Research into semi-solid metal forming techniques has been ongoing for an extended period with the aim of producing near-net shape products from aluminum alloys. The primary focus has traditionally been on casting alloys seeking to offer an alternative to the other processes such as high pressure die casting. Over the past twenty years, wrought aluminum alloys have also been explored for thixoforming operations as an alternative to traditional plastic deformation techniques. This research investigated the impacts of T6 heat treatment on the microstructural, mechanical, and corrosion properties of AA7075 alloy samples produced through cooling slope casting and subsequent thixoforming with different reheating durations. The selected alloy was chosen due to its widespread use in various industries, attributed to its excellent strength-to-density ratio achieved after T6 heat treatment. Building on optimized cooling slope casting parameters from a prior study, the standard solution treatment procedure following thixoforming with extended reheating times was found to be inadequate. Hardness and tensile tests revealed that specimens reheated for 120 min exhibited significantly reduced response to T6 treatment. Despite achieving the targeted hardness value of 154 HB with samples reheated for 20 min prior to thixoforming and T6 heat treatment, especially the elongation at break values were unsatisfactory. Potentiodynamic polarization tests indicated that corrosion primarily involved grain dissolution, with longer reheating times decreasing corrosion resistance due to increased amount of secondary phases and grain isolation. These findings highlight that while AA7075 alloy can be processed into semi-solid formable materials via cooling slope casting, issues such as hot tearing, micro-shrinkage, and physical defects post-thixoforming hinder the achievement of desired tensile properties.
Keywords
