Development of Inorganic Impregnated Phase Change Material(PCM) in the Pores of Activated Carbon

Abstract

Objectives Recently, energy-related research has shifted from developing alternative energy to the efficient management technology of the produced energy. As an alternative, research on phase change materials (PCMs) capable of absorbing and releasing heat as an energy medium has been conducted. This study developed a more efficient heat storage medium using activated carbon as a medium for the phase change material. At the same time, we developed a method for efficiently impregnating the phase change material into the activated carbon pores. Methods The activated carbon used in this experiment was charcoal powder activated carbon (250-350 mesh) and granular activated carbon. The inorganic phase change materials used in the experiment was manganese nitrate hexahydrate. The method for impregnating the phase change material was pressurization method and dilution method. The heat absorption / emission capacity of the developed material was examined within the range of 10℃ to 50℃. Results and Discussion The Scanning electron microscope (SEM) and Transmission electron microscopy energy-dispersive X-ray spectroscopy (TEM-EDX) analysis showed that the phase change material was filled in the pore of activated carbon. When the phase change material is filled by the pressurized method, the material properties of manganese nitrate hexahydrate are reflected, resulting in absorption and release of heat at each phase change temperature. As a result of experiments for the selection of the optimum solvent in the phase change material filling study using the dilution method, when ethanol was used as the solvent, the heat absorption was clearly observed even after the phase change material was loaded. As a result of selecting the optimal dilution ratio, the ratio of ethanol was determined to be 1:1 as the dilution ratio with the lowest amount of floating activated carbon. The optimal solvent removal method experimental results show that the heat absorption/release section occurred when the ethanol was removed by evaporation at 85℃ temperature. Conclusions 1) Both the pressurization method and the dilution method are filling methods in which inorganic phase change materials can be immobilized inside activated carbon, and heat absorption and release characteristics are maintained even after loading. 2) The heat absorption release was maintained for ethanol and the optimal dilution ratio was 1:1. 3) In case of the dilute solvent removal method, the heat absorption/release capacity was maintained when the solvent was removed using only the vaporization method.

Keywords

• phase change material(pcm)
• pore impregnation
• heat absorption/release
• activated carbon pores