Effect of solutionizing and double ageing treatments on the microstructural characteristics and tensile properties of Inconel 718 welds

Abstract

Inconel 718 joints were fabricated using the pulsating direct current gas tungsten arc welding (PDCGTAW) and laser-arc hybrid welding (LAHW) techniques using Ni-Cr-Mo-rich filler. A cyclic post-weld heat treatment (PWHT) comprising 980 °C/20 min/air cooling; followed by two-stage ageing 720 °C/8 h/furnace cooling and 620 °C/8 h/air cooling was performed on both joints. The liquation cracking was noticed on the heat-affected zone (HAZ) of the LAHW joints. Microstructural characteristics were assessed on the joints in both as-welded (ASW) and PWHT conditions. Regardless of the joints, the coarse Mo-rich segregates were noticed in the fusion zone (FZ) in the ASW conditions. On the contrary, the partial dissolution of MC, precipitation of δ-Ni3Nb needles and the coarsening of strengthening precipitates were observed on LAHW and PDCGTAW joints after subjecting to cyclic PWHT respectively. Tensile studies corroborated that there is a considerable enhancement in the tensile and 0.2% offset yield strengths of LAHW joints after being exposed to PWHT, despite the formation of HAZ liquation cracking.

Keywords

• Inconel 718
• Laser-arc hybrid welding
• Pulsed current gas tungsten arc welding
• Ageing treatments
• Microstructure characteristics
• Tensile properties