Stomatološki glasnik Srbije (Jan 2010)

Possible errors during the optical impression procedure

  • Todorović Aleksandar,
  • Lisjak Dejan,
  • Lazić Vojkan,
  • Špadijer-Gostović Aleksandra

DOI
https://doi.org/10.2298/sgs1001030t
Journal volume & issue
Vol. 57, no. 1
pp. 30 – 37

Abstract

Read online

Introduction. Modern technologies offer a range of benefits and significantly improve specific therapeutic procedures in dentistry. However, despite gaining experience and training there are still some mistakes in their implementation. The aim of this study was to describe the most common errors during intraoral scanning, 'optical impression' procedure, during CAD-CAM technology for production of dental restorations. Material and Methods. Cerec® 3D CAD-CAM system for one visit tooth reconstruction by inlays, onlays, endocrowns, half and complete crowns and veneers from the ceramic material was used in the study. Results. Analysis included 1564 reconstruction during 5 years. The most common causes of errors performing optical impression were the result of: improper preparation of teeth, the instability of the scanner in the mouth of the patient, incorrect position and angle of the scanner to the object scanning, contrast spray applied in uneven layer, the presence of fluid in the region scan, the presence of artifacts in the region gingival sulcus. Conclusion. Optical impression is faster procedure than conventional impression, but technologically sensitive. The most frequent errors are: improper handling of the scanner, inadequate tooth preparation, irregular powder application on the tooth and irregular use in the gingival sulcus.

Keywords