Experimental study and comparative numerical modeling of creep behavior of white oak wood with various distributions of earlywood vessel belt

Abstract

Abstract Many researches have been conducted to investigate creep behavior of wood; however, the effects of structure on wood creep behavior remain unclear. Therefore, the effects of existence and distribution of earlywood vessel belt on creep behavior of white oak (Quercus alba L.) wood were investigated by dynamic thermal mechanical analyzer (DMA) with double cantilever bending in this study. Besides, a comparative numerical modeling simulation on strain curves of white oak specimens was completed using Burger and Five-parameter model. Results revealed that instantaneous strain and 45-min strain of specimens decreased with increase in the distance between earlywood vessel belt and stress acting surface obviously. Additionally, instantaneous strain and 45-min strain of specimens remarkably increased with increase in temperature from 20 to 80 °C. An obvious bending creep behavior was observed with increase in temperature from 20 to 80 °C. Both Burger and Five-parameter model can effectively simulate the creep behavior of white oak specimens with R 2 values greater than 0.90. Furthermore, Five-parameter model illustrated a better fitting effect than Burger model in the final creep stage due to the introduction of a non-linear creep strain growth expression. It concluded that creep behavior of white oak wood strongly depends on the existence and distribution of earlywood vessel belt.

Keywords

• White oak (Quercus alba L.)
• Earlywood vessel belt
• Bending creep behavior
• Multivariate linear fitting
• Comparative numerical modeling