Ideal T1 laminar screw fixation based on computed tomography morphometry

Abstract

Abstract Background The application of laminar screws is an alternative fixation for the first thoracic vertebra (T1). This paper is to determine the anatomical characteristics for adequate laminar screw fixation, and present a modified method of sagittal reconstruction of T1 to provide more accurate measurements. Methods Computed tomography (CT) images of 62 patients (32 males, 30 females) were used for the analysis. The following parameters of the T-1 lamina were measured using Mimics software: lamina length, axis angle, minimal outer cortical width, cancellous width, minimal outer cortical height, cancellous height, and spinous process height. Right or left modified sagittal reconstructions (parallel to right or left screws) were innovatively used for measurement. Results There were no significant differences between the left and right sides for each measurement performed (P > 0.05), but significant differences were detected between males and females (P < 0.05). The mean length of the T1 lamina was 32.8 mm of the T1 minimal outer cortical width was 7.4 mm, and 3.8% of males had a minimal outer cortical width < 5 mm, while 8.6% of females had a minimal outer cortical width < 5 mm. The mean minimal outer cortical height was 10.8 mm, and 1.9% of males had a minimal outer cortical height < 9 mm, while 7.7% of females had a minimal outer cortical height < 9 mm. Conclusion This study suggests there are no anatomical limitations for T1 laminar screw placement in most people. The modified sagittal reconstruction method described allows for easy and precise measurement to aid in the insertion of laminar screws in T1, and gives good visualization of laminar screw insertion direction.

Keywords

• Laminar screw
• Upper thoracic spine
• CT scan
• Radiographic parameters