Evaluation of the Effect of Nanographene Oxide on Microleakage of Conventional and Resin-Modified Glass Ionomer

Abstract

Objectives. One of the important features of the restorative materials is the ability to seal and prevent the microleakage. Glass ionomer cement (GIC) still exhibits some microleakage despite establishing a chemical bond to the tooth. The aim of this study was to evaluate the effect of nanographene oxide (nGO) on the microleakage of conventional (CGIC) and resin-modified glass ionomer cement (RMGIC). Methods. Thirty intact extracted molars were used. Class V cavities were prepared on their buccal and lingual surfaces. The samples randomly divided into two main groups of CGIC and RMGIC; each of them was randomly subdivided into three subgroups, including the group without nGO (control), the group with 1% nGO, and the group with 2% nGO. After restoring the cavities, they were subjected to thermocycling (1,000 cycles at 5/55°C). Two percent basic fuchsin solution was used to perform the microleakage test, and then the sectioned samples were examined by a stereomicroscope 40x. Kruskal–Wallis test, Dunn’s test, and Mann–Whitney U test were used to analyze the data (P<0.05). Results. Group CGIC + 1% nGO at the gingival margin and group RMGIC + 1% nGO at both gingival and occlusal margins had significantly less microleakage than their control groups (P=0.008, P=0.002, P=0.023, respectively). Also, in these two groups, there were no significant differences between the microleakage of the occlusal and gingival margins (P=0.132, P=0.511, respectively), while in all other groups, the gingival microleakage was significantly higher than that of occlusal microleakage. Conclusions. The addition of 1% nGO significantly reduced the gingival microleakage of CGIC and the occlusal and the gingival microleakage of RMGIC, while the addition of 2% nGO did not cause a significant reduction in microleakage.