Hardening by Transformation and Cold Working in a Hadfield Steel Cone Crusher Liner

Abstract

This paper presents the characterization of a secondary cone crusher concave liner made of Hadfield steel used in Chilean mining after crushing copper minerals during all service life. During use, a cone crusher concave liner suffers indentation (cold working) and abrasion; this combination provides the concave with a layer that constantly renews itself, maintaining a surface highly resistant to abrasive wear. The results presented here were obtained using optical microscopy, microhardness test, measuring abrasion using the dry sand/rubber wheel apparatus, and x-ray diffraction peaks analysis through the classic Williamson–Hall method. After analysis of results, two hardened surfaces have been found—one a product of heat treatment and the other due to deformation during use. This work proposes ways to explain them; the first one uses a thermodynamic model to calculate stacking fault energy, and the second compares the liner with cold-rolled samples.

Keywords

• austenitic steel
• stacking fault energy
• hardening
• phase transformation
• cold working