Hybrid excitation flux switching motor with permanent magnet placed at middle of field coil slots and high filling factor windings

Abstract

Design and experimental studies on a hybrid excitation flux switching motor as a traction motor for hybrid electric vehicles drive are presented. A stator body of the motor consists of not only laminated silicon-iron electromagnetic steel and three-phase armature windings, but also both of field excitation coils and permanent magnets working together as a variable field magnetomotive force source. On the other hand, a rotor is composed of just laminated silicon-iron electromagnetic steel with salient poles like switched reluctance motor. To bring out the best in drive performances of the hybrid excitation flux switching motor as a variable flux motor for the application, each material adopted for the stator and rotor body should be designed properly in terms of motor efficiency, maximum torque and power densities and so forth. As some of them, in this paper, thinner silicon-iron electromagnetic steel sheet and permanent magnets with high remanent and low amount of Dysprosium used are applied for achieving higher motor efficiency. Moreover, all coils wound flatwise and edgewise using rectangular wires are introduced to realizing high filling factor for reduced copper losses. Experimental tests using a 60kW prototype of the motor demonstrates the designed motor has good motor efficiency under frequent operating points expected for the target vehicle drive.

Keywords

• hybrid electric vehicle
• hybrid excitation flux switching motor
• rectangular wire
• traction motor
• variable flux motor