Three-Dimensional Printing Properties of Polysaccharide Hydrocolloids–Unrinsed Sturgeon Surimi Complex Hydrogels

Abstract

Herein, the microstructure and mechanical properties of hydrogels consisting of unrinsed sturgeon surimi (URSS) and plant-derived polysaccharides such as κ-carrageenan (KC), konjac gum (KG), xanthan gum (XG), guar gum (GG) and sodium alginate (SA), were studied by texture analysis, rheological measurement and scanning electron microscopy (SEM). Rheological results showed that the apparent viscosity, storage modulus (G′) and loss modulus (G″) of URSS increased by addition of KC, KG, GG and SA. The gel strength of resultant surimi products fabricated with KG/URSS mixture was significantly higher than that of other groups. KG could significantly improve the hardness (44.14 ± 1.14 N), chewiness (160.34 ± 8.33 mJ) and cohesiveness (0.56 ± 0.02) of the unrinsed surimi gel. Adding SA and KC had no significant effect on the textural characteristics of printed gels. However, an apparent decrease in the relevant mechanical properties of printed hydrogels was observed when XG and GG were added into surimi. SEM indicated that the incorporation of KG and KC could further integrate the gel structure of URSS as compared to hindering the cross-linking of surimi protein by XG and GG, which were in accordance with gel strength and water-holding capacity. These results provided useful information to regulate the 3D printing performance in functionalized surimi-based material.

Keywords

• sturgeon
• unwashed surimi
• 3D printing
• hydrogel
• rheology