Case Studies in Thermal Engineering (Jun 2022)

A neem oil-based biodiesel with DEE enriched ethanol and Al2O3 nano additive: An experimental investigation on the diesel engine performance

  • Duraisamy Sakthivadivel,
  • Poongavanam Ganesh Kumar,
  • Rajendran Prabakaran,
  • V.S Vigneswaran,
  • Kamaraj Nithyanandhan,
  • Sung Chul Kim

Journal volume & issue
Vol. 34
p. 102021

Abstract

Read online

In this paper, an effort has been made to produce biodiesel from Neem oil (Azadirachta Indica) and to perform a comparative analysis on various blends with diethyl ether (DEE) and alumina nanomaterials at different volume fractions. The fraction of alumina oxide (Al2O3) nanomaterials with the blend (Pure Diesel 40% + Neem BD 40% + Ethanol) is varied in the range of 25, and 50 ppm. Experimental outcomes displayed that the physical and chemical properties of the biodiesel enhanced with the dispersion of alumina nanomaterials. The performance characteristics of the biodiesel blend such as brake thermal efficiency were increased up to 7.2% and brake specific fuel consumption was reduced up to 6.7% by adding the adding nanomaterial at 25 ppm of alumina nanomaterials compared with the pure diesel fuel. This is because of the higher surface area of the nanomaterial, which acts as the positive catalyst and increases the reaction rate. The Al2O3 positively altered the critical parameters like the ignition temperature and the ignition delay of a DE. Moreover, the addition of alumina nanomaterials gave better emission characteristics on the account of reduction in the HC, CO, and smoke emissions at higher loads compared to NDB. Al2O3 enhances the performance and the anti-knocking ability of the fuel. At 100% load conditions, the nitrogen oxide (NOx) emissions of NBD2 (Diesel 40% + Neem BD 40% + Ethanol 20% (90% volume + DEE 10%) are lower than NBD by 17.5%.

Keywords