Effect of Polymer Adjuvant Type and Concentration on Atomization Characteristics of Nozzle

Abstract

(1) Background: Various types of adjuvants are added during application to enhance the spraying effect, but most adjuvant formulations are proprietary products, and their exact compositions have not been disclosed. (2) Methods: The spatial distributions of droplet sizes and velocities generated by the atomization of different polymer adjuvants were measured based on the phase Doppler interferometer (PDI) measurement method. The sub-area statistical method was used to quantitatively analyze the droplet characteristics at various points below the nozzle. (3) Results: The polymer (polyethylene oxide (PEO))/associative surfactant (sodium dodecyl sulfate (SDS)) can increase the droplet size and velocity of the solution after atomization by increasing the amount of the polymer/associative surfactant to reduce the equilibrium surface tension of the solution and increase the viscosity. Different concentrations of polymer/associative surfactant atomization produced larger droplet sizes and better uniformity than polymer/non-associative surfactant (polysorbate-20 (Tween20)). At the same position, the relationship between droplet velocities for the three adjuvant combinations was roughly as follows: PEO/SDS solution had the highest velocity, followed by PEO solution, and PEO/Tween20 solution had the lowest velocity. (4) Conclusions: The optimal of droplet size distribution can be achieved by adding appropriate amounts of associative surfactants to polymers.

Keywords

• polymer adjuvant
• atomization
• nozzle
• PDI