Scientific Reports (Jun 2024)

CFD–DEM method is used to study the multi-phase coupling slag discharge flow field of gas-lift reverse circulation in drilling shaft sinking

  • Longhui Guo,
  • Hua Cheng,
  • Zhishu Yao,
  • Chuanxin Rong,
  • Zongjin Wang,
  • Xiaoyun Wang

DOI
https://doi.org/10.1038/s41598-024-64519-1
Journal volume & issue
Vol. 14, no. 1
pp. 1 – 22

Abstract

Read online

Abstract To elucidate the distribution law of the multiphase coupling slag discharge flow field in gas-lift reverse circulation during drilling shaft sinking, a numerical analysis model of gas–liquid–solid multiphase coupling slag discharge was established by CFD–DEM (Coupling of computational fluid dynamics and discrete element method) method, taking the drilling of North Wind well in Taohutu Coal Mine as an example. This model presented the distribution of the multiphase flow field in the slag discharge pipe and at the bottom hole, and was validated through experimentation and theoretical analysis. Finally, the impact of factors, including bit rotation speed, gas injection rate, air duct submergence ratio, and mud viscosity on the slag discharge flow field was clarified. The results indicated that the migration of rock slag at the bottom of the well was characterized by “slip, convergence, suspension, adsorption, and lifting”. The slag flow in the discharge pipe exhibited the states of “high density, low flow rate” and “low density, high flow rate”, respectively. The multiphase fluid flow patterns in the well bottom and slag discharge pipe were horizontal and axial flows, respectively. The model test of the gas lift reversed circulation slag discharge and the theoretical model of the bottom hole fluid velocity distribution confirmed the accuracy of the multiphase coupling slag discharge flow field distribution model. The rotation speed of the drill bit had the most significant impact on the bottom hole flow field. Increasing the rotation speed of the drill bit can significantly enhance the tangential velocity of the bottom hole fluid, increase the pressure difference between the bottom hole and annular mud column, and improve the adsorption capacity of the slag suction port. These findings can provide valuable insights for gas lift reverse circulation well washing in western drilling shaft sinking.

Keywords