OPTIMIZATION OF THE TEHNOLOGICAL PROCESS OF THE PART ‘’CYLINDER PISTON” WITH NX 7.5 SOFTWARE

EFTIMIE Dorin; BLANARU Viorel

Journal of Industrial Design and Engineering Graphics (Nov 2012)

OPTIMIZATION OF THE TEHNOLOGICAL PROCESS OF THE PART ‘’CYLINDER PISTON” WITH NX 7.5 SOFTWARE

EFTIMIE Dorin,
BLANARU Viorel

Affiliations

EFTIMIE Dorin: Ph.D., Assist. Professor at Engineering Faculty of Braila, ,,Dunarea de Jos’’University of Galati
BLANARU Viorel: graduate student (AACDMET) at Engineering Faculty of Braila, ,,Dunarea de Jos’’ University of Galati

Journal volume & issue: no. 7

Abstract

Read online

This paper aims to present the optimization of processing the part “piston cylinder” with NX 7.5 software. CAD modeling is realized and analyzed with finite elements (CAE) simulating deformation and maximum stretching and virtual technology manufacturing (CAM) where were highlighted aspects regarding the sequence of the manufacturing operations and the technological parameters.

Technological process optimization CAD, CAE, CAM.

Published in Journal of Industrial Design and Engineering Graphics

ISSN: 1843-3766 (Print); 2344-4681 (Online)
Publisher: SORGING
Country of publisher: Romania
LCC subjects: Technology: Building construction: Architectural engineering. Structural engineering of buildings; Technology: Engineering (General). Civil engineering (General): Engineering design
Website: http://sorging.ro/jideg/

About the journal

Abstract

Keywords