Temperature and electric field distribution of tri‐post insulator in DC‐GIL based on numerical multiphysics modelling

Abstract

Abstract The temperature distribution of the tri‐post insulator in a ±500 kV direct current gas‐insulated transmission lines (DC‐GIL) is investigated. The influence of thermal gradient on the electric field characteristics is investigated as well. A horizontally installed GIL model is applied in the simulation. The thermal and electric parameters of the insulator are measured and employed. The temperature results indicate that the gas shows a layered distribution pattern while the insulator shows a radial distribution pattern. The temperature of the upper post is higher. With increasing ambient temperature, the surface temperature increases linearly following the variation of ambient temperature. With increasing load current, the temperature near the conductor shows an obvious increase. With increasing gas pressure, the temperature decreases due to the promotion of convection. Besides, the electric field strength of the insulator surface increases if the surface temperature increases during the variation of operating conditions. And the peak of field strength moves towards the enclosure. After 10 h, the temperature reaches a quasi‐stationary state. Since the thermal gradient affects the distribution of gas density and electric field strength of the insulator, the investigation of temperature characteristics is necessary when evaluating the insulating performance of DC‐GIL with insulators.

Keywords

• electrical installation
• epoxy insulators
• finite element analysis
• gas insulated transmission lines
• heat transfer
• HVDC power transmission