Microstructure and mechanical properties of functional gradient materials of high entropy alloys prepared by direct energy deposition

Abstract

In this study, FeCrCoNiMo0.5W0.75 HEAs functional gradient materials were prepared by the direct energy deposition (DED) technique, and the phase transition, microstructure and mechanical properties of the materials along the building direction were investigated. The material realizes a transition from a single FCC phase to an FCC + TCP phase from the bottom to the top. The bottom and middle of the material are typical dendritic (DR)-interdendritic (ID) structures, and at the top, due to the precipitation of the eutectic structure σ phase and μ phase, the material transforms into a hypoeutectic structure of FCC + eutectic. According to the EBSD results, the interior of the material is mainly columnar crystals that grow vertically to the molten pool. This unidirectional columnar growth makes the material have a strong texture in the direction. In addition, a large degree of grain refinement is exhibited from the bottom to the top, with the grain size reduced from 19 μm to 6.5 μm. According to the TEM results, the density of dislocations is much higher near the phase and grain boundaries than in other regions, and dislocation entanglement is formed by the continuous accumulation of loose dislocations. The micro-hardness of the material increased along the construction direction up to 892.5HV0.5, and the material has good compressive strength up to 2041 ± 45 MPa. The material has excellent wear resistance and high-temperature wear resistance, forming a continuous oxide layer at 800 °C, which greatly reduces the friction coefficient and wear rate.

Keywords

• Functional gradient materials
• Direct energy deposition
• High-entropy alloys
• Microstructure evolution
• High-temperature friction wear