Frontiers in Neuroscience (Feb 2020)

On-Chip TaOx-Based Non-volatile Resistive Memory for in vitro Neurointerfaces

  • Maksim Zhuk,
  • Sergei Zarubin,
  • Igor Karateev,
  • Yury Matveyev,
  • Evgeny Gornev,
  • Gennady Krasnikov,
  • Dmitiry Negrov,
  • Andrei Zenkevich

DOI
https://doi.org/10.3389/fnins.2020.00094
Journal volume & issue
Vol. 14

Abstract

Read online

The development of highly integrated electrophysiological devices working in direct contact with living neuron tissue opens new exciting prospects in the fields of neurophysiology and medicine, but imposes tight requirements on the power dissipated by electronics. On-chip preprocessing of neuronal signals can substantially decrease the power dissipated by external data interfaces, and the addition of embedded non-volatile memory would significantly improve the performance of a co-processor in real-time processing of the incoming information stream from the neuron tissue. Here, we evaluate the parameters of TaOx-based resistive switching (RS) memory devices produced by magnetron sputtering technique and integrated with the 180-nm CMOS field-effect transistors as possible candidates for on-chip memory in the hybrid neurointerface under development. The electrical parameters of the optimized one-transistor–one-resistor (1T-1R) devices, such as the switching voltage (approx. ±1 V), uniformity of the Roff/Ron ratio (∼10), read/write speed (<40 ns), and the number of the writing cycles (up to 1010), are satisfactory. The energy values for writing and reading out a bit ∼30 and ∼0.1 pJ, respectively, are also suitable for the desired in vitro neurointerfaces, but are still far too high once the prospective in vivo applications are considered. Challenges arising in the course of the prospective fabrication of the proposed TaOx-based RS devices in the back-end-of-line process are identified.

Keywords