Flow softening and recrystallization accompanied flow in AZ61 magnesium alloy during thermomechanical processing

Abstract

The present work deals with characterizing the recrystallization accompanied flow and high temperature softening behavior of an extruded AZ61 magnesium alloy. This was supported by conducting a set of hot compression tests at temperatures in the range of 250–450 °C under the strain rate ranging from 0.001 to 0.1s−1. The flow curves at all thermomechanical conditions indicated high fractional softening representing the domination of dynamic recrystallization mechanism. Through a new quantitative approach, “Arrhenius type model”, “modified Avrami equations” and Poliak and Jonas method were simultaneously employed to investigate the kinetic of dynamic recrystallization. It was revealed that the strain required for the same amount of recrystallization fraction increased with decreasing deformation temperature, and at a specified temperature, the required strain increases with increasing strain rate. Interestingly, an anomaly was found at 400 °C under the strain rate of 0.001s−1, where the recrystallization kinetic was faster than that of what was recorded at 450 °C. This anomaly was discussed relying on the nanoprecipitation of γ-phase at the prior boundaries and sub-boundaries which prohibited the grain boundary migration and also the rotation and coalescence of adjacent sub-grains.

Keywords

• Magnesium alloy
• Thermomechanical processing
• Recrystallization kinetics
• Microstructure
• Avrami equation