Research progress and prospect in wire arc additive manufacturing magnesium alloy

LIU Hongjie; LIU Wencai; SUN Jiawei; WANG Xiyao; KUANG Siyu; WU Guohua

doi:10.11868/j.issn.1001-4381.2022.000380

Cailiao gongcheng (Feb 2024)

Research progress and prospect in wire arc additive manufacturing magnesium alloy

LIU Hongjie,
LIU Wencai,
SUN Jiawei,
WANG Xiyao,
KUANG Siyu,
WU Guohua

Affiliations

LIU Hongjie: National Engineering Research Center of Light Alloy Net Forming, School of Materials Science and Engineering, Shanghai Jiao Tong University, Shanghai 200240, China
LIU Wencai: National Engineering Research Center of Light Alloy Net Forming, School of Materials Science and Engineering, Shanghai Jiao Tong University, Shanghai 200240, China
SUN Jiawei: National Engineering Research Center of Light Alloy Net Forming, School of Materials Science and Engineering, Shanghai Jiao Tong University, Shanghai 200240, China
WANG Xiyao: National Engineering Research Center of Light Alloy Net Forming, School of Materials Science and Engineering, Shanghai Jiao Tong University, Shanghai 200240, China
KUANG Siyu: National Engineering Research Center of Light Alloy Net Forming, School of Materials Science and Engineering, Shanghai Jiao Tong University, Shanghai 200240, China
WU Guohua: National Engineering Research Center of Light Alloy Net Forming, School of Materials Science and Engineering, Shanghai Jiao Tong University, Shanghai 200240, China

DOI: https://doi.org/10.11868/j.issn.1001-4381.2022.000380
Journal volume & issue: Vol. 52, no. 2
pp. 16 – 30

Abstract

Read online

Wire arc additive manufacturing (WAAM) has received extensive attention from researchers due to its high deposition rate, high material utilization, low cost, and ability to manufacture large-scale components. It is expected to be widely used in rapid forming of magnesium alloys. The current types and requirements of wires used in WAAM of magnesium alloy were summarized. Then, the current preparation methods suitable for WAAM of magnesium alloy were introduced. The manufacturing technology, deposition mechanism, microstructure and mechanical property of various WAAM-processed magnesium alloys were discussed. Finally, the problems such as the few types of available wires and the uncontrollable shape and property of components for wire arc additive manufacturing of magnesium alloys were analyzed. The optimization of properties and application of components for wire arc additive manufacturing of magnesium alloys were forecasted.

Published in Cailiao gongcheng

ISSN: 1001-4381 (Print)
Publisher: Journal of Materials Engineering
Country of publisher: China
LCC subjects: Technology: Electrical engineering. Electronics. Nuclear engineering: Materials of engineering and construction. Mechanics of materials
Website: http://jme.biam.ac.cn/CN/1001-4381/home.shtml

About the journal

Abstract

Keywords