Photocontrollable Resistivity Change in Nanoparticle-Doped Liquid Crystal Alignment Layer: Voltage Holding and Discharging Properties of Fringe-Field Switching Liquid Crystal Modes

Abstract

In liquid crystal (LC) displays, deriving an optimum resistance level of an LC alignment polyimide (PI) layer is important because of the trade-off between the voltage holding and surface-discharging properties. In particular, to apply a power-saving low-frequency operation scheme to fringe-field switching (FFS) LC modes with negative dielectric LC (n-LC), delicate material engineering is required to avoid surface-charge-dependent image flickering and sticking problems, which severely degrade with lowering operation frequency. Therefore, this paper proposes a photocontrolled variable-resistivity PI layer in order to systematically investigate the voltage holding and discharging properties of the FFS n-LC modes, according to the PI resistivity (ρ) levels. By doping fullerene into the high-ρ PI as the photoexcited charge-generating nanoparticles, the ρ levels of the PI were continuously controllable with a wide tunable range (0.95 × 1015 Ω∙cm to 5.36 × 1013 Ω∙cm) through Ar laser irradiation under the same LC and LC alignment conditions. The frequency-dependent voltage holding and discharge behaviors were analyzed with photocontrolled ρ variation. Thus, the proposed experimental scheme is a feasible approach in PI engineering for a power-saving low-frequency FFS n-LC mode without the image flickering and image sticking issues.

Keywords

• photocontrolled resistivity
• liquid crystal alignment polyimide layer
• voltage holding property
• discharging property
• fringe-field switching liquid crystal mode