Journal of Dairy Science (Mar 2024)

The mouthpiece chamber vacuum pattern indicates the cessation of milk flow and suits as an indicator to reduce teat end vacuum at a quarter level

  • Kathrin Schlapbach,
  • Momena Khatun,
  • Carl Oskar Paulrud,
  • Rupert M. Bruckmaier

Journal volume & issue
Vol. 107, no. 3
pp. 1778 – 1787

Abstract

Read online

ABSTRACT: We investigated the suitability of the quarter mouthpiece chamber vacuum (MPCV) as an indicator for cessation of quarter milk flow to potentially adjust the teat end vacuum at a quarter level. We tested the hypothesis that a MPCV increase is a clear indicator of quarter milk flow cessation. In addition, we tested if a quarter-individual vacuum reduction at MPCV increase reduces the mechanical effect on the teat. Ten dairy cows were milked twice daily with a quarter-specific vacuum supply with continuously high (51 kPa; TRT51) or low vacuum setting (41 kPa; TRT41), or high vacuum setting combined with a quarter-specific vacuum reduction by 10 kPa immediately after the quarter-specific MPCV increase (TRT51/41). Whole udder milk flow was continuously recorded. Each treatment was repeated at 4 subsequent milkings. The high vacuum settings (TRT51; TRT51/41) reached higher values in peak flow rate and average milk flow and consequently shorter machine-on time. The time from start of milking until the steep increase of the MPCV was shorter in front than rear quarters, and hence the time from start of MPCV increase until end of milking was longer in front than rear teats. Teat condition of the right front teats was measured for teat wall diameter by ultrasound and teat tissue thickness by cutimeter at 5 and 20 min after each experimental milking. The teat measurements were taken at the teat tip (distal barrel) and 2 cm above the teat tip (proximal barrel). The proximal teat wall diameter tended to be higher in TRT51 than in TRT41, both 5 and 20 min after milking. The distal teat wall diameter at 5 min was greater in TRT51 than in TRT41. In TRT51/41 the teat wall diameter at both locations was intermediate, not significantly different from either TRT51 or TRT41. The distal teat tissue thickness was greater in TRT51 than in TRT41, and tended to be greater in TRT51/41 than in TRT41 at 5 min. The proximal teat tissue thickness at 5 min was higher in TRT51 and TRT51/41 than in TRT41. The teat tissue thickness decreased from 5 to 20 min only in the proximal barrel. The quarter-individual MPCV increase appears to be a suitable indicator of the cessation of milk flow. The lack of a significant reduction of mechanical effect on the teat by a reduced vacuum of 41 kPa indicates that the vacuum level chosen may be still too high under conditions of a separate vacuum supply for each quarter, which prevents a vacuum drop caused by the whole udder milk flow.

Keywords