Scientific Reports (Sep 2024)
Enhancing the performance of paraffin's phase change material through a hybrid scheme utilizing sand core matrix
Abstract
Abstract Smart waste management and valorisation is presented in the current investigation. Iron is collected from mining wastewater stream and augmented with sand as a supporting material to produce sand core. The sand core pellets encapsulated in paraffin’s to enhance its feasibility as phase change material (PCM). Sand core was characterized using X-ray diffraction and Scanning Electron Microscope (SEM) augmented with energy dispersive X-ray spectrum analysis. Experimental test is achieved by mixing sand core/iron and paraffin that is signified as an encapsulated phase change material. The encapsulated sand core-PCM is embedded in varies mass weights of percentages of 0.5, 1.0, 1.5 and 2.0% and labeled as 0.5%-sand core-PCM, 1.0%-sand core-PCM, 1.5%-sand core-PCM and 2.0%-sand core-PCM. The encapsulated sand core-PCM is embedded into a heat exchanger of the vertical type model that is connected with a flat plate solar collector. Such collector is heating the heat transfer carrier, which is exposed to the heat exchanger for melting the PCM. The experimental work is conducted across the solar noon where the solar intensity in the region is reached to 1162 W/m2 at the time of conducting experiments. Water is applied and supposed as the working heat transfer fluid transporter and pumped into the system at the rate of 0.0014 kg per second. The experimental result revealed that the heat gained recorded an enhancement from 7 to 48 kJ/min when the 1.5%-sand core-PCM system is applied. Thus, the results showed the system is a good candidate by increasing the system efficiency with 92% as a potential solution of solar energy storage at the off-time periods.
Keywords
