The impacts of M/A constituents decomposition and complex precipitation on mechanical properties of high-strength weathering steel subjected to tempering treatment

Abstract

The impact of microstructure evolution on the mechanical properties of a typical 500 MPa-grade weathering steel produced by an identical thermo-mechanical control process and different tempering treatments at 450–650 °C were thoroughly investigated mainly using scanning electron microscopy (SEM) equip with an electron backscatter diffraction (EBSD), high-resolution transmission electron microscopy (HRTEM), and X-ray diffractometer (XRD). Results indicated that the as-rolled steel consists of granular bainitic ferrite (GBF) and a considerable amount of martensite/austenite (M/A) constituents, exhibiting unsatisfied mechanical properties. As the tempering temperature increased from 450 to 550 and 650 °C, the massive twin-type M/A constituents decomposed preferentially into carbides following the sequence of Fe3C→(Cr, Mn, Fe)3C→(Cr, Mn, Fe)3C + (Cr, Mn)23C6, with a small amount of fine lath-type M/A constituents remained. The matrix recovered with the bainitic ferrite laths merged, the dislocation density decreased and the proportion of high-angle grain boundary (HAGB) increased. Nanoscale (Ti, Nb)C and ε-Cu particles also precipitated simultaneously, leading to an increase of yield strength. The strain hardening capacity and hence the tensile strength reduced resulting from the decomposition of M/A constituents. Moreover, the impact toughness was first enhanced by tempering at 450–600 °C with the decreasing twin-type M/A constituents content and increasing HAGBs proportion, and then deteriorated by tempering at 650 °C due to the precipitation of necklace-like M23C6 carbides at the grain boundaries. An optimum mechanical property combination was achieved via tempering at 550–600 °C.

Keywords

• Weathering steel
• Tempering
• M/A constituent
• Carbides
• ε-Cu particles
• Mechanical properties