Heliyon (Aug 2023)

Damage to seeds by screw working bodies

  • Mayya Sukhanova,
  • Eduard Khasanov,
  • Alexander Butenko,
  • Shamil Fayzrakhmanov,
  • Rinat Fayzullin

Journal volume & issue
Vol. 9, no. 8
p. e18973

Abstract

Read online

Seed damage caused by screw working bodies of agricultural machines reduces the seed quality and increases the total cost of crop production. This paper describes the impact interaction of a particle with screw flights when seeds are fed into the transportation zone. There are velocity dependences during the impact and reflection of seeds on the screw surface at the maximum distance of the radius from the screw rotation axis. The potential energy lost by seeds when interacting with screw flights is determined. The paper considers the way transporting the seed material by screw working bodies impacts seed damage. The potential energy accumulated after impact by the reflecting surface and the particle depends on the magnitude and direction of the falling velocity to the screw belt, the auger geometric and kinematic parameters (the screw diameter; the inclination angle of the helix to the screw axis and the angular velocity), as well as the physical and mechanical properties of the particle and the reflecting surface (recovery and friction coefficients). Previous studies have shown that the critical angular velocity of the screw flight depends on the screw casing and the reduction factor of the circumferential velocity. In turn, the reduction factor depends on the transported seed material and the geometric parameters of the screw. It is possible to diminish the destruction of the seed material due to impact interaction with the working surface of the screw by reducing the inclination angle of the screw flight α, the angular speed of the screw rotation ω and its radius R. It also requires direct the seed flow closer to the rotation center. Reducing injury to seeds during transportation in a screw device requires a higher critical angular velocity of the screw. To increase the working angular velocity of the screw without exceeding its threshold of critical angular velocity, it is advisable to use screws with a large pitch and polymer screws with a wider pitch.

Keywords